It is essential to use extra care when using a rough terrain scissor lift. Drivers should be fully aware of the surrounding environment. Long booms on the equipment act as levers from the center of the drive unit. Like for instance, a 6 inch bump could result in a 3 foot bounce when the operator is at the driver controls. Consider all other traffic nearby, because they may not know that you are moving. Plan your assent cautiously. Park the boom lift on a flat surface that has no mud or water. These areas conceal deep potholes which can be probably cause the occupants to fall if the tires fell into the holes. If provided, use all of the outriggers, completely extended. Be sure to only utilize wooden chalk blocks that are approved.
Many lifts work from a metal platform on the end of the boom. The extended booms act as levers from the center of the drive unit. A 6-inch bump can lead to a 3-foot bounce while you are at the driver controls. Be aware of all other traffic. They might not be aware that you are moving. Plan your assent. Park the boom lift on a flat surface free of any mud or water. These areas can conceal deep potholes in which the lift tires can fall, tipping the occupants. Extend all outriggers, if provided, completely. Place only approved wooden chalk blocks beneath the outrigger pads in order to prevent the unit from moving.
Overhead power lines are a serious danger for lift operators regardless of what lift is being used. For instance, if the operator of the platform is not being aware, or if the platform is being controlled by ground personnel which can not accurately access proximity to wiring and therefore, either the platform itself or the worker could be easily brought into contact with electrical wires. The employee could be electrocuted unfortunately unless correctly insulated.