Change a Propane Tank
Propane fueled forklifts are frequently utilized in warehouses. The forklift is designed with the propane tank mounted at the back of the driver. The tanks, that look a lot like beer kegs, have to be replaced from time to time because they have a limited lifespan. Forklift operators should utilize care when handling propane tanks. Compressed gases are dangerous, especially because the gas is flammable. Always utilize care when removing and replacing propane tank to avoid injury.
1 To change a propane tank, first stop the lift truck while leaving the engine running, and turn the valve on the tank off. Let the lift truck run until the engine dies. This procedure burns off the gas inside the transfer hose which connects the engine and the tank. Before taking the next steps, put on the proper safety equipment, such as insulated gloves made of either neoprene or leather. It is vital for you to protect your skin from touching the compressed gas, which is extremely cold.
2 Disconnect the hose from the tank and take the holding straps off to remove the tank. When you put in a new tank, reattach the holding straps and reconnect the hose at the valve of the tank by tightening the nut.
3 Leaks can be checked simply by applying soapy water to the valve and slightly opening it. If there is a leak, it would cause bubbles to froth from around the valve. If this occurs, check the connection hose at the nut and the valve area. The connecting nut should be re-tightened if you detect any leaks in the valve area, and then do the leak checking process all over again. Persistent leaks mean that both the nut and connecting hose should be replaced. Then again, if replacing the hose and nut still does not stop the leak, the tank must be replaced.
4 Finally, open the valve all the way to enable the gas to fill the connecting hose. After that you can start the forklift and continue working.